Alpine CDA-7878R - Manual (Page 12)

10
-EN
Blackout Mode On and Off
When the Blackout mode is turned on, the display
will turn off to reduce power consumption.
This additional power enhances the sound quality.
1
Press and hold the B.OUT button for at least 2
seconds to start the blackout mode. By doing so
the display will turn off.
NOTE
If any button on the unit is pressed during the blackout
mode, the function will be displayed for 5 seconds to
show the operation before returning to Blackout mode.
To cancel the blackout mode, press and hold the
B.OUT button for at least 2 seconds.
Switching the Display Modes
You can select the display pattern mode from
three display patterns. You can also deactivate the
display.
1
Press the DISP (DISPLAY) button to select the
desired Display pattern mode.
Each press changes the display patterns.
→ Pattern1 → Pattern2 → Pattern3 → Display OFF
Basic Operation
f UP
g DN
TITLE
DISP/B.OUT
SETUP
TUNE
2
Press the f UP button repeatedly to select
"SRC DHE."
Each press of the f UP button changes the
modes as shown:
∗ Displayed when you set SUB-W to ON.
NOTE
If you press the g DN button, the display scrolls in
reverse sequence.
3
Press the TUNE button to toggle the mode
between SRC DHE ON and SRC DHE OFF.
SRC DHE ON:
You can set the DHE/EQ independently for each
music source (e.g., radio, CD, MP3, etc.).
SRC DHE OFF:
You can set the same DHE/EQ for all the music
sources at the same time.
NOTE
The initial setting at the factory is SRC DHE OFF.
4
Press the SETUP button to set the selected
mode.
Setting the DHE/EQ for each Music
Source
You can set the DHE/EQ independently for each
music source (e.g., radio, CD, MP3, etc.).
1
Press and hold the SETUP button for at least 2
seconds.
T.S.M.
TUNER
SUB-W
(switching phase)
∗
SUB-W
STEREO/MONO
∗
AUX
MUTE
SCROLL BEEP
CONTRAST
DISC/FOLDER
DEMO
SRC DHE
REGIONAL PI SEEK FM-LEVEL SUB-W
↔ ↔ ↔ ↔
↔
↔
↔
↔ ↔ ↔
↔
↔
↔
↔
↔