Alpine CDA-7878R - Manual (Page 8)

6
-EN
SETUP
TUNE
g DN f UP
MODE/Audio Control
→ SUB-W → BALANCE
VOLUME
←
FADER
←
Subwoofer On and Off
1
Press and hold the SETUP button for at least 2
seconds.
2
Press the f UP button repeatedly to select
“SUB-W.”
3
Press the TUNE button to toggle mode between
SUB-W ON and SUB-W OFF.
4
Press the SETUP button after setting the SUB-W
ON.
5
Press the MODE button repeatedly to select the
SUB-W mode.
6
Rotate Audio Control knob until the desired
sound is obtained in each mode.
Adjusting Display Contrast
You can adjust the display contrast for better
visibility.
1
Press and hold the SETUP button for at least 2
seconds.
2
Press the f UP button repeatedly to select
“CONTRAST.”
3
Press the TUNE button to adjust the contrast of
the display. You can adjust in a range of -5 and
+5.
The initial setting at the factory is "0."
4
Press the SETUP button to set the selected
mode.
Basic Operation
Adjusting Source Signal Level
If the difference in volume level between the CD
player and FM radio is too great, adjust the FM
signal level as follows.
1
Press and hold the SETUP button for at least 2
seconds.
2
Press the f UP button repeatedly to select
"FM-LEVEL."
Each press of the f UP button scrolls the
modes as follows:
∗ Displayed when you set SUB-W to ON.
NOTE
When you press the g DN button, the display scrolls
in the reverse sequence.
3
Press the TUNE button to select the FM signal
level mode. Each press toggles between "FM-
LEVEL HI" (High) and "FM-LEVEL LO" (Low).
4
Press the SETUP button to activate the normal
mode.
TUNER
SUB-W
(switching phase)
∗
SUB-W
STEREO/MONO
∗
AUX
MUTE
SCROLL BEEP
CONTRAST
DISC/FOLDER
DEMO
SRC DHE
REGIONAL PI SEEK FM-LEVEL SUB-W
↔ ↔ ↔ ↔
↔
↔
↔
↔ ↔ ↔
↔
↔
↔
↔
↔