Alpine CDA-7878R - Manual (Page 18)

16
-EN
RDS Operation
Recalling Preset RDS Stations
1
Press the "F" button. The indicator will
illuminate.
2
Press the AF button to activate the RDS mode.
The display shows "AF" when the RDS mode is
activated.
3
Press the "F" button to activate the normal mode.
The
indicator will turn off.
4
Press the 1 through 6 buttons in which your
desired RDS station is preset. If the preset
station's signal is weak, the unit automatically
searches and tunes to a stronger station in the
AF (Alternative Frequencies) list.
5
If the preset station and the stations in the AF list
cannot be received:
When the PI SEEK setting is on (refer to "PI
SEEK Setting" on page 17), the unit searches
again for a station in the PI (Programme
Identification) list.
If there are still no stations receivable in the
area, the unit displays the frequency of the
preset station and the preset indicator
disappears.
If the signal level of the Regional (Local) station
being tuned becomes too weak to receive, press
the same preset button to tune in a Regional
station in other district.
NOTE
For presetting the RDS stations, refer to the Radio
Operation section. The RDS stations can be preset in the
FM1, FM2 and FM3 bands only.
Receiving RDS Regional (Local)
Stations
1
Press and hold the SETUP button for at least 2
seconds to activate the setting mode.
2
Press the f UP button repeatedly to select
"REGIONAL". Each press of the f UP button
scrolls the modes as shown:
∗ Displayed when you set SUB-W to ON.
NOTE
If you press the g DN button, the display scrolls in
reverse sequence.
3
Press the TUNE button to turn on or off the
"REGIONAL" mode.
In the "REGIONAL OFF" mode, the unit
automatically keeps receiving the related local
RDS station.
4
Press the SETUP button to deactivate the setting
mode.
TUNE T.INFO
SETUP/F AF
Preset buttons (1 through 6)
PTY g DN f UP
TUNER
SUB-W
(switching phase)
∗
SUB-W
STEREO/MONO
∗
AUX
MUTE
SCROLL BEEP
CONTRAST
DISC/FOLDER
DEMO
SRC DHE
REGIONAL PI SEEK FM-LEVEL SUB-W
↔ ↔ ↔ ↔
↔
↔
↔
↔ ↔ ↔
↔
↔
↔
↔
↔