Setting up the lan, Etting, P the – ADC MM701F User Manual
Page 54
Setting Up the WAN
48
MM701F User Manual
S
ETTING
U
P THE
LAN
If you are operating in Router mode and in a LAN environment, then you also need to set your
LAN protocol, Ethernet Port IP address, and subnet mask.
If you prefer, you may use the default values of
10.0.0.1
for the Ethernet Port IP Address, and
255.255.255.0
for the subnet mask.
1
From the
Main Menu
, select
LAN Setup
. The LAN setup screen displays.
2
From the
LAN Setup
menu, select
LAN Protocol
by typing
1
.
3
Do one of the following from the LAN Mode menu:
•
Type
1
to select
Router.
•
Type
2
to select
Bridge
. You must configure an IP address for the LAN port to use a
Browser or Telnet to manage the MM701F.
4
From the
LAN Setup
menu, type
2
or
3
to select
IP Address
or
IP Net Mask
(respectively), then
enter the values supplied by your LAN administrator or use the default values.
5
From the
LAN Setup
menu, type
4
to select
Default Gateway
, then enter the
Default Gateway
IP
address supplied by your access provider.
6
From the
LAN Setup
menu, type
10
to select
Apply
.
Apply
immediately activates the changes
that you have made for this session.
7
From the
Main Menu,
type
5
to select
Save New System Configuration
and save these settings.
LAN
1. LAN Protocol
Bridge
2. IP address
10.0.0.1
3. IP Net Mask
255.255.255.0
4. Default Gateway
5. DHCP
None
6. DHCP Range Low Address
N/A
7. DHCP Range High Address
N/A
8. DHCP Gateway Address
N/A
9. DHCP DNS
N/A
10. Apply
Select Parameter to edit (Return to exit) ->