Fes en po f es en po – Ascaso Factory Electrical Fryer User Manual

Page 10

Advertising
background image

4

Frying recommendations

Let all foods to be fried be

perfectly drained in order to avoid

water steam and splashes.

Do not fill the basket completely.

Introduction of big amount of

pieces of food to be fried

originates a remarkable froth

production in the oil, specially if

products have a high degree of

humidity.

Put the basket into the hot oil in

a slowly way to allow water

contained in foods evaporate,

avoiding eventual oil overflows.

Do not immerse foods in oil until

it has reached the right

temperature, as this would cause

oil cooling and water saturation

that may boil once the oil

reached frying temperature,

eventually causing oil overflows.

Frost food must be fried in small

quantities, as instant evaporation

of water contained in them may

cause oil overflows.

3

Remove the fryer's lid.

Check that emptiness tap is on and that

regulation thermostat is in “0” position.

Fill the tank with oil until reaching the maximum indicated level. In

case of 6l fryer until reaching half tank (3 litres approximately).

Connect the machine to the mains.

Push the ON-OFF switch to

turn the machine on.

Turn thermostat handle

clockwise and adjust it at the

desired temperature.

Temperature indicator light will

be on until the oil reaches the

desired temperature. The

moment the light is off is when

foods may be put in the basket

trying not to heap them up, then

putting the bag slowly into hot

oil.

Tank lid must never located on

its position during frying.

After frying time has finished (see

attached board), lift the basket

Frying procedures

and shake it horizontally

without taking it out of the tank

in order to avoid splashes. Hang

it on head support handle,

turn thermostat handle

counterclockwise to “0” position.

When oil is cold put the lid on

top of the fryer.

Disconnect the fryer from the

mains.

If the fryer is not being used but

it should be ready for immediate

use in any moment, thermostat

temperature must be adjusted to

100º C. In this way, and without

causing any damage to the oil,

the fryer will be perfectly ready

for use in just a few seconds.

2

4

3

9

6

5

4

180º
190º
160º
165º
160º
190º
170º
180º
190º
190º

4 Min.
4 Min.
4 Min.
7 Min.
4 Min.
2 Min.
5 Min.
4 Min.
2 Min.
3 Min.

For achieving excellent

“French fries”, we

recommend to have them

fried in two steps, first

whiten them during 4

minutes, lift the basket, let

them drain and then fry

them again during 2 minutes

for making them crunchy.

It is recommended the use of a

low acidity oil, preferably olive

because of its low evaporation

degree, being also possible to

use mixes of olive and sunflower

oils.

The use of soy oil is not

recommended because of its low

ebullition point.

It is not recommended to use oil

an excessive number of times, as

ignition point is reduced

considerably and it may cause

sudden splashes.

When the oil loses its original

colour turning into dark brown

colour, produces smoke or plenty

of froth, it must be entirely

replaced, instead of adding

additional new oil.

The added oil level must not be

below the minimum level. A very

low oil level may be inflammable.

On 6l model the basket must be

immersed at least half of the

level.

5

7

8

5

Fish
Calamari (squid)
Vegetables
Meat
Croquettes
Buns
Chicken
Potatoe whitened
Potatoe crunchy
Potatoe frosted

Operation

2

F

ES
EN

PO

F

ES
EN

PO

Advertising