ACTiSYS VER. 061030 CAM-6500 - Manual (Page 13)

8
Pin 4 Line Lock
Pin 5 System Initialization (for
upgrade)
Pin 6 Reserved
RS-232 is reserved for internal use only; The Pin 3 and Pin 4, they
are used for termination and Link Lock adjustment respectively.
The Pin 5 is mainly used for return to factory default of camera
setting.
3. Dome ID Setting
Use the switch to change your speed dome ID by turning the
arrow to the desired number respectively. For instance, if the
speed dome ID is 123, the ID switch should be set as below:
centesimal decimal single digit
d
o
4. Dome Control Protocol
Protocol is a specific set of rules, procdures used for data
communications. Basing on the protocol of your management
software that you are going to use. Use the switch to set your
dome control protocol and the baud rate. Refer to table below and
turn the arrow to choose a protocol for your speed dome.
Switch No. Protocol Baud Rate
01 Pelco D 2400
02 Pelco P 4800
07 DSCP 9600
11 Pelco D 4800
12 Pelco D 9600
13 Pelco P 2400
NOTE: No two speed domes should be given the same ID, or
communication conflict may occur.
NOTE: The number “0” should locate upwards as shown in
above diagram for correct switch definition.