HP Designjet 2500.3500cp Printer series - Manual (Page 292)

Front-Panel Messages
Message Explanations and Actions
12-14
Replace
printhead(s)
Close window You are in the ink system replacement process, and lifted the window when instructed.
The printer is waiting for you to replace a printhead, or you can close the window
without making any changes. (If you have persistent problems, see
If You Have
Problems Reseating a Printhead 11-41 .)
Replace ■■■*
Close right door You are in the ink system replacement process, and opened the right door when
instructed.
The printer is waiting for you to replace the printhead cleaners indicated by *s, and
then close the right door.
Replacement of ink
system
recommended
→
You are about to finish the ink system replacement process, and the printer
recommends replacing one or more of the four ink systems (for example, because they
have passed their specified life).
Press the
↓
key to continue. You will see the status message “Low on ink”. Then press
the Replace Ink System key to replace the ink systems that will be indicated.
Replacement of lens
cover
recommended
→
The printhead alignment procedure, or the printhead check procedure, or a calibration
check has failed because the lens cover is dirty and needs replacing. Printing may
continue but the image quality is not assured.
Press
↓
to continue. See the instructions for lens cover replacement on page 10-3,
Lens Maintenance. Spare lens covers are inside the right door.
Resource area full
Unable to save res. (HP DesignJet 2500CP only) The printer’s hard disk is full. You are attempting to save
resources. The printer is unable to process the request.
You need to remove some of the resources from the hard disk, for example, saved print
files, halftones, or fonts that you don’t use. Then try saving the resource again.
Roll empty
Load new roll You have used all of the media roll.
Load a new roll of media.
Roll misaligned
Reload roll Roll media is skewed.
Reload media.
Set transport
→
Yes
Mode
→
No
You have selected transport mode in the front-panel menu. The printer is waiting for
you to accept or reject the transport mode. Accepting transport mode starts the process
of removing all ink systems.
Press
↑
to accept or press
↓
to reject.
Sheet load
→
Roll load
→
Press
↑
to load sheet media.
Press
↓
to load roll media.
Message Explanation and Action