HP Designjet 2500.3500cp Printer series - Manual (Page 83)

Working with Media
Installing a New Roll into the Printer
3-33
4 Place the spindle vertically on the floor, with the fixed spindle media guide at the
bottom. Take off the removable spindle media guide from the top of the spindle, and
slide the new roll onto the spindle. The leading edge of the media must wind
clockwise as shown below.
5 Install the removable spindle media guide onto the end of the spindle.
a Push down on the media guide, making sure that the guide is flush against the
ends of the roll.
b Then push the middle section in.
B B
A A
B
Correct Incorrect
C4723119
C4723132