HP XP P9500 Storage - Manual (Page 115)

24
.
After the installation finishes, check the path information as described in
Checking the Path Configuration on page 3-69 , and make sure that you
have successfully installed HDLM in a single-path configuration.
25
.
Connect cables to all the HBAs to change the configuration to a multi-path
configuration.
26
.
Check the path information as described in Checking the Path
Configuration on page 3-69 to make sure that you have successfully
assembled a multi-path configuration.
When Oracle RAC Is Used
To install HDLM when Oracle RAC is used:
1
.
Shut down all the hosts.
2
.
Make sure that all the hosts that make up the cluster system have been
fully shut down.
3
.
Restart each host.
Start them in a single-path configuration.
4
.
Log on to Windows as a member of the Administrators group.
5
.
Save the license key file directly under the Windows installation-
destination drive. Also, instead of using the license key, you can directly
specify the license key during the installation of HDLM.
installation-drive:\hdlm_license
The license key file will be deleted after the installation finishes.
6
.
Perform the installation.
¢
If you are not performing an unattended installation, insert the DVD
into the drive.
In the displayed window, click the Install button next to for
Windows of Hitachi Dynamic Link Manager Software.
If no window is displayed, manually run the installer (setup.exe).
The program checks whether HDLM has already been installed. If
HDLM 5.4 or earlier has been installed, the KAPL09129-E message will
appear. If this happens, carry out the procedure shown in Migrating
from HDLM 5.4 or Earlier to HDLM 5.5 or Later on page 3-65 . If
HDLM 5.5 or later has been installed, the KAPL09173-W message will
appear. If this happens, carry out the procedure shown in Upgrade
Installation or Re-installation of HDLM on page 3-64 . If no message
appears, go to step 7.
¢
If you are planning to perform an unattended installation, execute the
installhdlm utility.
At the command prompt, execute the following command:
drive-to-which-the-installation-DVD-is-inserted:\HDLM_Windows
\DLMTools\installhdlm -f installation-information-settings-
file
Creating an HDLM Environment
3-47
Hitachi Dynamic Link Manager User Guide for Windows ®