HP XP P9500 Storage - Manual (Page 151)

Figure 3-5 Hitachi Network Objectplaza Trace Utility 2 Release 2.0
Dialog Box.
2
.
In Number of Files, change the number of integrated trace files.
The default is 4. You can specify a value from 1 to 16.
The value you specify here will apply to n in program-installation-
destination-drive:\Program Files\HITACHI\HNTRLib2\spool
\Hntr2n.log (n indicates a file number).
3
.
In File Size(KB), change the size of an integrated trace file.
The default is 256 (kilobytes). You can specify a value from 8 to 8192.
Specify a value greater than or equal to the setting of Buffer Size(KB).
4
.
In Buffer Size(KB), change the buffer size.
Change the buffer size for the monitoring cycle.
The default is 64 (kilobytes). You can specify a value from 8 to 2048.
Specify a value smaller than or equal to the setting of File Size(KB).
5
.
In Interval Timer(Sec), enter a value to shorten the monitoring cycle.
The default is 10 (seconds). You can specify a value from 1 to 300.
6
.
In Lookout Span(Sec), enter a value to specify the interval for
monitoring the number of messages to be output to the integrated trace
file.
The default is 0 (seconds). You can specify a value from 0 to 3600.
If you specify 0, you cannot adjust the number of messages to be output
because the system ignores the setting of Max Messages / Span.
7
.
In Max Messages / Span, enter a value to specify the maximum
number of messages to be output to the integrated trace file at the
monitoring interval specified in Lookout Span(Sec).
Creating an HDLM Environment
3-83
Hitachi Dynamic Link Manager User Guide for Windows ®