HP XP P9500 Storage User Manual

Page 116

Advertising
background image

Specify n for the restart key in the installation-information settings

file.
This command checks whether HDLM has already been installed. If

HDLM 5.4 or earlier has been installed, the KAPL09129-E message will

appear. If this happens, carry out the procedure shown in

Migrating

from HDLM 5.4 or Earlier to HDLM 5.5 or Later on page 3-65

. If

HDLM 5.5 or later has been installed, the KAPL09183-E message will

appear, and then the upgrade installation or re-installation will be

performed.
After the installation is complete, go to step 14.

7

.

The program checks the MPIO driver version, and then installs the MPIO

driver. If a message appears asking you whether you want to install the

MPIO driver, make sure that no multi-path management software other

than HDLM is installed.

¢

If multi-path management software other than HDLM is installed, click

the Cancel button to cancel the installation, remove the multi-path

management software, and then install HDLM.

¢

If no multi-path management software other than HDLM is installed,

click the Next button to continue the installation.

8

.

Specify a license key file or enter a license key by following the

instructions shown in the messages that appear in the window.
If a license key file was saved in step 5, specify that license key file.
If a license key file is not being used, specify the license key directly.

9

.

Specify the installation folder by following the instructions shown in the

messages that appear in the window.
The utility for registering HDLM persistent reservation keys (dlmprsvkey)

will be automatically executed. However, creation of the PRSV key might

be unsuccessful if, for example, an NIC does not exist. If the PRSV key is

created with time information only, or if key creation fails, a dialog box

will prompt you to enter the PRSV key.
If this dialog box appears, go to step 10; otherwise, go to step 12.

10

.

Enter the PRSV key by following the instructions shown in the dialog box.
The PRSV key is required for the HDLM functions to properly operate.

Also, the value of the PRSV key must be unique for each host.

11

.

If the KAPL09128-W message appears, you will need to re-enter the

correct PRSV key.
If a message does not appear, go to the next step.

12

.

The message Select Storage system to be managed. is displayed.

Click the Next button.
In an Oracle RAC environment, because an EMC DMX series or EMC CX

series LU cannot be set as an HDLM management-target device, do not

select EMC Symmetrix DMX Series, CLARiiON CX Series. Similarly,

because an HP EVA series LU cannot be set as an HDLM management-

target device, do not select HP StorageWorks EVA Series.

13

.

Follow the instructions shown in the messages that appear in the window.

3-48

Creating an HDLM Environment

Hitachi Dynamic Link Manager User Guide for Windows

®

Advertising