Parameters used when displaying lu information -57 – HP XP P9500 Storage User Manual
Page 247
¢
For command devices, -CM is added to the end of the emulation type
of the storage system (for example, DF600F-CM).
Parameters Used When Displaying LU Information
When displaying LU information, if the -item parameter, -c parameter, or
the -c -item parameter is specified at the same time as the -lu parameter,
you can add and display items and display a summary of LU information. This
section describes each parameter and the LU information and displayed
items.
Parameters to display LU information:
-lu
When neither the -c nor -item parameter is specified with the -lu
parameter, the information about the LU recognized by HDLM is
displayed. The sorting key is iLU and its configuration information is
displayed for each LU.
Note that:
¢
For the Thunder 9500V series, Lightning 9900 series, Lightning 9900V
series, Hitachi USP series, Hitachi AMS2000/AMS/WMS/SMS series,
HUS100 series, Universal Storage Platform V/VM series, and Virtual
Storage Platform series LU information is displayed for each storage
system.
¢
For the EMC DMX series and EMC CX series, LU information is
displayed for each vendor ID.
¢
For the HP EVA series, LU information is displayed for each
vendor_ID_product_ID.
By using the sub-parameter, -hdev or -pathid, you can filter the LU
information to be displayed. If you do not specify -hdev or -pathid, the
information about all LUs recognized by HDLM is displayed. For details on
the content of each displayed item, see
The sub-parameters are:
-hdev host-device-name
Displays information only for the paths accessing the specified host
device.
Specify a drive letter to indicate the desired host device. You cannot
specify the host device unless a drive letter has been assigned. The
host-device-name string is case sensitive. If the command ends with
the KAPL01064-W or KAPL01013-E message, follow the recommended
action in the message.
-pathid AutoPATH_ID
Use this parameter to display only the information about the LU that
is connected to the path with that specified AutoPATH_ID.
-exlu
Command Reference
6-57
Hitachi Dynamic Link Manager User Guide for Windows
®