HP P2000 G3 MSA Array Systems - Manual (Page 47)

HP P2000 G3 FC MSA System User Guide 47
Figure 18 Connecting a USB cable to the CLI port
3. Enable the CLI port for subsequent communication:
• Linux customers should enter the command syntax provided in
Preparing a Linux computer before
cabling to the CLI port on page 45.
• Windows customers should locate the downloaded device driver described in Downloading a
device driver for Windows computers on page 45, and follow the instructions provided for proper
installation.
4. Start and configure a terminal emulator, such as HyperTerminal or VT-100, using the display settings in
Table 6 on page 47 and the connection settings in Table 7 on page 47 (also, see the note following
this procedure).
.
1 Your server or laptop configuration determines which COM port is used for Disk Array USB Port.
2 Verify the appropriate COM port for use with the CLI.
5. In the terminal emulator, connect to controller A.
6. Press Enter to display the CLI prompt (#).
The CLI displays the system version, MC version, and login prompt:
a. At the login prompt, enter the default user manage.
b. Enter the default password !manage.
If the default user or password — or both — have been changed for security reasons, enter the secure
login credentials instead of the defaults shown above.
Table 6 Terminal emulator display settings
Parameter Value
Terminal emulation mode VT-100 or ANSI (for color support)
Font Terminal
Translations None
Columns 80
Table 7 Terminal emulator connection settings
Parameter Value
Connector COM3 (for example) 1,2
Baud rate 115,200
Data bits 8
Parity None
Stop bits 1
Flow control None
Service
CACHE
ACTIVITY
LINK
DIRTY
Host Interface
Not Shown
LINK
ACT
CLI CLI
HOST
Host Interface
Not Shown
CLI
Connect USB cable to CLI
port on controller faceplate