P2000 6gb 3.5” 12-drive enclosure, Msa70 3gb drive enclosure, 17 leds — hp p2000 6gb rear panel – HP P2000 G3 MSA Array Systems User Manual
Page 69
HP P2000 G3 FC MSA System User Guide
69
P2000 6Gb 3.5” 12-drive enclosure
MSA70 3Gb drive enclosure
A P2000 G3 MSA System controller can also be attached to an MSA70 3Gb drive enclosure running
firmware version 2.18 or later. For information about the MSA70 3Gb drive enclosure, including detailed
steps to upgrade the firmware, see the HP StorageWorks 70 Modular Smart Array Enclosure User Guide
located on the MSA2000 G2 Software Support/Documentation CD shipped with your product, or at
.
Table 17
LEDs — HP P2000 6Gb rear panel
LED
Description
Definition
1
Power supply LEDs
See
2
Unit Locator
Off — Normal operation.
Blinking white— Physically identifies the expansion module.
3
OK to Remove
Not implemented.
4
Fault/Service Required
Amber — A fault has been detected or a service action is required.
Blinking amber — Hardware-controlled powerup or a cache flush
or restore error.
5
FRU OK
Green — Expansion module is operating normally.
Blinking green — System is booting.
Off — Expansion module is not OK.
6
SAS In Port Status
Green — Port link is up and connected.
Off — Port is empty or link is down.
7
SAS Out Port Status
Green — Port link is up and connected.
Off — Port is empty or link is down.
0
0
IN
OUT
0
0
IN
OUT
2
3
4
5
7
1
6
1