HP TopTools - Manual (Page 16)

HP Toptools for Unicenter User Guide
Figure 2-4. Setup stops and restarts the Toptools services.
Setup displays the port number on which it intends to service requests. The default is 5041. If for some reason this
TCP port is not available on your system, select an available port, and specify it here. A list of reserved TCP ports
is available in the \winnt\system32\drivers\etc\services file. Listed ports may not be in use, but have already been
specified for use by other applications. You can see a list of actively used ports by using ‘netstat –p tcp’.
Regardless of which free TCP port you select, make a note of it as you will be prompted to enter the port during the
platform bridge component installation.
Figure 2-5. TCP port 5041 is the default used by Toptools for Unicenter.
Next, setup requests the address of the Unicenter system. Enter the Community string and IP address into the fields.
Page 16