HP TopTools - Manual (Page 68)

HP Toptools for Unicenter User Guide
The models listed in the table below can be configured using SNMP/Trap Configuration or Automatic Management.
Models supported by SNMP/Trap Configuration and Automatic Management
advancestack 10 Base-T Switching Hub
advancestack Switch 800T, 2000B
procurve 10 Base-T hub 12M, 24M
procurve 10/100 hub 12M, 24M
procurve Switch 2400, 2424, 4000, 1600, 8000
To automatically configure HP networking products to send traps to the NNM server, there are two options:
1. Use the SNMP/Trap Configuration menu item (Figure 5-36) to configure thresholds and trap destinations on the
selected device.
Figure 5-36. SNMP/Trap Configuration dialog
2. Access HP Toptools for Hubs and Switches SNMP/Trap Configuration using the following procedure.
Right click on a map icon and select HP Toptools ->Toptools Home to launch the Toptools Server home
page. In Toptools, display the available devices by selecting Devices, Devices by Type, Networking
Devices. Right click on the desired device(s) and select SNMP/Trap Configuration from the action
menu. This will display the Device Configuration dialog. To configure a new trap destination select the
Trap Receivers tab. Enter the address of the new device to receive traps. Click Add, Apply. You will be
asked to enter a password to log on to the device(s) to complete the configuration. By selecting multiple
devices in the list, you are able to specify trap destinations for all of them that support the SNMP/Trap
Configuration feature.
Note: To use Device View or SNMP/Trap Configuration to set trap destinations, the read community for the
selected device must be set to public. You will be prompted to enter the correct write community.
Page 68