HP TopTools - Manual (Page 30)

HP Toptools for Unicenter User Guide
Figure 3-15. HP Netserver Node Classes (right panel).
Press Next..
The table in Figure 3-16 should list all the classes on the right hand side for the “NSAAgent”. Repeat this for
“Ping” and the Netservers classes.
When you are done adding the Netserver classes to agents of interest, press the “Next” button. This will bring up
the following screen:
Figure 3-16. Select subnets where these agents should be managed.
Select the subnets on which management of these agents should take place. Unlike auto-discovery, which takes
place interactively using the Unicenter auto-discovery window, DSM actively contacts agents to determine their
state. For example, the Ping Agent is using the ICMP layer of the IP stack on the end nodes. The Ping Agent is
polled, by default, every 5 minutes to determine if the system is up and running. By selecting a subnet in this
screen, you configure what networks are actively monitored using the DSM. Complete this screen and press “Next”.
Page 30