HP TopTools - Manual (Page 25)

HP Toptools for Unicenter User Guide
Setup determines where Unicenter is installed and displays this information:
Figure 3-7. Setup indicates the destination of installation files.
Next, the installation program displays a warning about prerequisites. These were detailed in the previous section.
Figure 3-8. Setup indicates prerequisites for this installation.
At this point, the installation program prompts you to enter the IP address of the system running the Toptools server
and server bridge, along with the TCP port number specified during server bridge installation. The default port is
5041; however, if you specified a different port number earlier, then you must enter the new number now.
Page 25