HP XP P9000 Command View Advanced Edition Software - Manual (Page 207)

Remarks
Default
value Specifiable val-
ues
Item specified Options
Pair com-
mand
Flush: The copy pair is suspended after the data
is synchronized.
Purge: The copy pair is suspended at the
moment that a suspend request is issued, even
when there is data that has not been
synchronized yet.
Notes:
• Either the Direction option or the Synchron-
ization option needs to be specified for the
split pair command. (Both options cannot
be specified at the same time.)
• When a split operation is performed on Cnt
Ac-J pairs or C/T groups, Purge cannot be
selected.
• The Flush option is not displayed when the
following two conditions are both satisfied:
- The operation target is Cnt Ac-A.
- The primary volume is in the remote site.
In this case the default value of the Syn-
chronization is ”Purge”.
Flush Flush, Purge
Whether to sus-
pend the copy
pair after the data
is synchronized.
Synchron-ization
Force
SELECT(ALL),VOLUNIT is specified in the BCM
command. The command is also executed for
pairs whose status is not available for the
command. The command is executed on a pair
basis even though execution by group is
possible.
Notes:
• The Force option affects all pairs, regardless
of their individual statuses.
• When Purge is selected for a split operation
to be performed on Cnt Ac-J copy groups,
the Force option is inactive.
• When a split operation is performed on Cnt
Ac-A or Cnt Ac-J copy groups, if the value
specified for the Direction option is different
from the current copy direction, the Force
option is inactive.
off on, off
The operation is
performed on a
volume basis. The
command is ex-
ecuted for all
pairs regardless
of their status.
The values "Read Only" and "Read Write" are
displayed in this order.
Read Only
Read Only,
Read Write
Whether to permit
writing to the S-
VOL after the split
operation.
Secondary
Mode
User Guide 207