HP XP P9000 Command View Advanced Edition Software - Manual (Page 472)

Indicates that no value is specified for the configuration information managed by Replication Manager
Before this information can be displayed, a value must be specified for the information in Replication
Manager. (This does not apply to hyphens contained in license information.)
Blank
Indicates that Replication Manager acquired blank information from the information source.
(Unknown icon) or Unknown
(For the summary copy pair status, the Unknown icon is displayed. For the copy pair state, Unknown
is displayed.)
Indicates that Replication Manager cannot determine the pair status due to any of the following reasons
(unknown):
• The settings are set not to acquire copy pair statuses.
• The configuration does not allow copy pair statuses to be acquired.
• The configuration information has already been acquired, but the copy pair information has not.
To display this information, you need to perform the corresponding operation as follows:
• If the settings are set not to acquire copy pair statuses, change the setting so that the desired in-
formation can be acquired.
• If the configuration does not allow copy pair statuses to be acquired, change the configuration.
• If the copy pair information has not yet been acquired, refresh the copy pair status.
Display format of multi-valued information items for a
management target
For a specific management target, a single information item might have multiple values. In this case,
each value is separated by a comma (,) or a line feed.
For example, when several mount points have been specified using Volume Manager, multiple values
are displayed for the mount point information in the dialog box that displays detailed information.
Similarly, when a single LU is shared among multiple hosts, multiple values are displayed for host
information. In such cases, the information is displayed on a separate line for each host, and the
mount points for each host are comma-separated and displayed on one line.
Example of displayed information items (LUN, Copy type, mount point, and host)
Host Mount point Copy type LUN
Host_A
Host_B /mnt,/mnt2
/mnt,/mnt2
Cnt Ac-S LUN1
Host_A
Host_B /mnt,/mnt2
/mnt,/mnt2
Cnt Ac-S LUN2
Display format of copy type
The copy type is displayed using an abbreviation. The following table shows the copy types and the
display formats supported by Replication Manager.
Display formats 472