HP Deskjet F2140 All-in-One Printer - Manual (Page 27)

TIP: To help prevent rips, wrinkles, and curled or bent edges, store all paper flat in
a resealable bag. If the paper is not stored properly, extreme changes in temperature
and humidity might result in curled paper that does not work well in the HP All-in-One.
To load 10 x 15 cm ( 4 x 6 inch) photo paper with tab in the input tray
1. Remove all paper from the input tray.
2. Insert the stack of photo paper into the far-right side of the input tray with the short
edge forward. Ensure that the side you want to print on faces down. Slide the stack
of photo paper toward the device until it stops.
Load the photo paper so that the tabs are closest to you.
TIP: For more help on loading small-size photo paper, refer to the guides
engraved in the base of the input tray for loading photo paper.
3. Slide the paper-width guide inward until it stops at the edge of the paper.
Do not overload the input tray; make sure the stack of paper fits within the input tray
and is no higher than the top of the paper-width guide.
For best results, set the paper type before copying or printing.
Related topics
• Recommended papers for printing and copying
• Change the print settings for the current job
• Set the copy paper type
Load index cards
You can load index cards into the input tray of the HP All-in-One to print notes, recipes,
and other text.
For best results, set the paper type before copying or printing.
NOTE: The HP All-in-One leaves a 1.2 cm (.5 inch) border on one short edge. Before
printing many cards, print one test card to make sure that the border does not crop
your text.
Load paper 25
Loa
d
o
rig
in
als and load
paper