HP Photosmart C8180 All-in-One Printer - Manual (Page 203)

HP All-in-One not found
Cause: This error applies only to USB-connected devices. The USB cable is not
plugged in properly.
Solution: If the HP All-in-One is not properly connected to the computer,
communication errors can occur. Make sure the USB cable is securely connected to
the HP All-in-One and the computer, as shown below.
For more information, see:
“Communication problems over a USB connection” on page 145
Improper shutdown
Cause: The last time the HP All-in-One was used, it was not turned off properly. If
the HP All-in-One is turned off by turning off the switch on a power strip or by using
a wall switch, the device can be damaged.
Solution: Press the On button to turn the device on and off.
Two-way communication lost
Cause: The HP All-in-One is turned off.
Solution: Look at the display on the HP All-in-One. If the display is blank and the
On button is not lit, the HP All-in-One is turned off. Make sure the power cord is firmly
connected to the HP All-in-One and plugged into a power outlet. Press the On button
to turn on the HP All-in-One.
Cause: The HP All-in-One is not connected to the computer.
Chapter 14
202 Troubleshooting
T
roub
les
hoot
ing