HP Photosmart C8180 All-in-One Printer User Manual
Page 44
To print the wireless test report
1.
Touch Setup on the display.
2.
Touch Network.
NOTE:
If the menu option you want is not visible on the screen, touch or
to scroll through all the menu options.
3.
Touch Wireless Network Test.
The Wireless Network Test prints.
Related topics
“Network troubleshooting” on page 158
Change advanced network settings from the control panel settings
The advanced network settings are provided for your convenience. However, unless you
are an advanced user, you should not change any of these settings.
This section contains the following topics:
•
•
Set link speed
You can change the speed at which data is transmitted over the network. The default is
Automatic.
To set link speed
1.
Touch Setup on the display.
2.
Touch Network.
NOTE:
If the menu option you want is not visible on the screen, touch or
to scroll through all the menu options.
3.
Touch Advanced Setup.
4.
Touch Set Link Speed.
5.
Touch the link speed that matches your network hardware.
•
Automatic
•
10-Full
•
10-Half
•
100-Full
•
100-Half
Change IP settings
The default setting for the IP settings is Automatic, which sets the IP settings
automatically. However, if you are an advanced user, you might want to manually change
the IP address, subnet mask, or the default gateway. To see the IP address and subnet
mask of the HP All-in-One, print a network configuration page from the HP All-in-One.
Connect to a network
43
Finish
set
up