HP Photosmart C8180 All-in-One Printer - Manual (Page 35)

4. Touch Wireless Setup Wizard.
This runs the Wireless Setup Wizard.
The wireless network test also runs, performing a series of diagnostic tests to
determine whether network setup is successful. The wireless network test prints upon
completion of the test.
5. Touch the name of the network you wrote down in step 1.
If you do not see your network name in the list
a. Touch Enter a New Network Name (SSID).
The visual keyboard appears.
b. Enter the network name (SSID). Touch the appropriate letters or numbers on the
visual keyboard.
NOTE: You must enter the exact uppercase (capital) and lowercase (small)
letters. Otherwise, the wireless connection will fail.
c. When you have finished entering the new network name, touch Done, and then
touch OK.
TIP: If the HP All-in-One is unable to discover the network based on the
network name you entered, you will see the following prompts. You may want
to move the HP All-in-One closer to the computer and try running the Wireless
Setup Wizard again to automatically discover the network.
d. Touch Infrastructure.
e. Touch WEP encryption or WPA encryption.
If you do not want to use WEP encryption, touch No, my network does not use
encryption. Go to step 7.
6. If prompted, enter your WPA or WEP key as follows:
a. Touch the appropriate letters or numbers on the visual keyboard.
NOTE: You must enter the exact uppercase (capital) and lowercase (small)
letters. Otherwise, the wireless connection will fail.
b. When you are finished entering the WPA or WEP key, touch Done.
c. Touch OK to confirm.
The HP All-in-One will attempt to connect to the network. If a message says you
entered an invalid WPA or WEP key, check the key you wrote down for your new
network, follow the prompts to correct the key, and then try again.
7. When the HP All-in-One connects successfully to the network, install the software on
each computer that will use the device over the network.
To connect the HP All-in-One with SecureEasySetup
1. Activate SecureEasySetup on your wireless router or access point.
2. Touch Setup on the display.
3. Touch Network.
NOTE: If the menu option you want is not visible on the screen, touch or
to scroll through all the menu options.
Chapter 4
34 Finish setting up the HP All-in-One
Finish set
up