HP 3000 Enterprise Virtual Array - Manual (Page 70)

NOTE:
The terms initiator and host are used interchangeably. The initiator is the host that is accessing
the storage.
e. Click the Discovery tab, ( Figure 23 ).
Figure 23 Adding an IP address
.
f. Click Add to add the IP address of Port 1 on the mpx100/100b.
g. Click OK to exit.
h. Click the Targets tab. The target status is Inactive ( Figure 24 ).
Figure 24 Inactive target status
.
i. Select a single target and then click Log On.
j. Click Automatically restore this connection when the system boots (do not enable multipath),
and then click OK (
Figure 25 ).
The target status is Connected.
Setting up the iSCSI Initiator and storage 70