HP Command View EVA Software - Manual (Page 66)

Running HP P6000 Command View in a multi-homed environment
When HP P6000 Command View is installed in a multi-homed environment, the services at startup
bind to the first available IP address. View the login page or the browser web link to view the IP
address used by HP P6000 Command View. You can change this IP address binding by modifying
the configuration files as follows:
1.
Open cveva.cfg located in the folder C:\Program Files\Hewlett-Packard\
Sanworks\Element Manager for StorageWorks HSV\config
.
2. Add the following entry in Webserver Section
Section WebServer
{
address xxx.xxx.xxx.xxx // newly added–ipaddress or the FQDN
3. In the C:\Program Files\Hewlett-Packard\Sanworks\Element Manager for
StorageWorks HSV
folder, open cv-eva.url.
4. Find the line that contains URL=https://localhost:2374, and replace the localhost with
the IP address or the FQDN name of the host where HP P6000 Command View is running.
IMPORTANT: The HP P6000 Command View server must have a unique IP address to ensure
management lock verification.
Configuring SNMP credentials
Starting with HP P6000 Command View 10.1, you can specify the protocol to send SNMP v1,
v2, or v3 traps.
1.
From the settings point of view session pane, click Management Options.
The Management Options window opens.
2. Under Notification options, select SNMP notification agent options.
The SNMP Agent Setting window opens.
3. Select the SNMP version and trap format.
If you select SNMPv3, additional options including authentication protocol are available for
you to select.
4. Click Save changes.
NOTE: These settings are not persisted across HP P6000 Command View upgrades. You can
however, save the cveva.cfg file before upgrading.
66 Configuring HP P6000 Command View (advanced tasks)