HP Designjet T920 ePrinter series - Manual (Page 43)

Menu item Sub-menu item Sub-menu item Values and Description
DHCPV6 Policy Router Specified : The stateful auto-configuration method
to be used by the print server is determined by a router.
The router specifies whether the print server obtains its
address, its configuration information, or both from a
DHCPv6 server.
Router Unavailable : If a router is not available, the print
server should attempt to obtain its stateful configuration
from a DHCPv6 server.
Always : Whether or not a router is available, the print
server always attempts to obtain its stateful
configuration from a DHCPv6 server.
Primary DNS Use this item to specify an IPv6 address for a primary DNS
server that the print server should use.
NOTE: This item will appear only if Manual
configuration is a higher priority than DHCP in the Config
Precedence table, configured through the embedded
Web server.
Secondary DNS Use this item to specify an IPv6 address for a secondary
DNS server that the print server should use.
NOTE: This item will appear only if Manual
configuration is a higher priority than DHCP in the Config
Precedence table, configured through the embedded
Web server.
Proxy Server Specifies the proxy server to be used by embedded
applications in the device. A proxy server is typically used
by network clients for Internet access. It caches Web
pages, and provides a degree of Internet security, for
those clients.
To specify a proxy server, enter its IPv4 address or fully-
qualified domain name. The name can be up to 255
octets.
For some networks, you may need to contact your
Independent Service Provider (ISP) for the proxy server
address.
Proxy Port Type the port number used by the proxy server for client
support. The port number identifies the port reserved for
proxy activity on your network, and can be a value from 0
to 65535.
Security Print Sec Page Yes : Prints a page that contains the current IPsec security
settings on the HP Jetdirect print server.
No (default): A security settings page is not printed.
Secure Web For configuration management, specify whether the
embedded Web server will accept communications using
HTTPS (Secure HTTP) only, or both HTTP and HTTPS.
HTTPS Required : For secure, encrypted communications,
only HTTPS access is accepted. The print server will
appear as a secure site.
HTTP/HTTPS optional : Access using either HTTP or HTTPS
is permitted.
NOTE: The factory default setting depends on the print
server model.
ENWW Front-panel menu items 35