Adding a disk drive, Removing the drive blank, Sequential building of vertical disk groups – HP 3000 Enterprise Virtual Array User Manual
Page 54
Advertising
CX8167-ST
2
1
Figure 16 Sequential building of vertical disk groups
1. Disks installed in first group
2. Disks installed in second group
Adding a disk drive
This section describes the procedure for adding a Fibre Channel disk drive.
Removing the drive blank
1.
Grasp the drive blank by the two mounting tabs (see
).
2.
Lift up on the lower mounting tab and pull the blank out of the enclosure.
CXO7359B ˚
1
2
Figure 17 Removing the drive blank
1. Upper mounting tab
2. Lower mounting tab
54
Enterprise Virtual Array operation
Advertising