Configuring an iscsi initiator in windows – HP QLogic QMH4062 1GbE iSCSI Adapter for c-Class BladeSystem User Manual
Page 6
Setup 6
d.
IP_Subnet_Mask [255.255.255.0]: Type the appropriate subnet mask, and then press the
Enter key.
e.
IP_Gateway [0.0.0.0]: Press the Enter key to accept the default.
f.
Enable IPv6 [off]: Press the Enter key to accept the default.
g.
Press the Enter key to continue.
9.
Select 3: Save changes and reset HBA (if necessary) on the options menu.
10.
Enter Yes at the prompt for both ports.
11.
Type p, and then press the Enter key.
12.
Type p, and then press the Enter key. This returns you to the CNA iSCSI Configuration menu.
13.
Select 4: Target Configuration on the CNA iSCSI Configuration menu.
14.
Select the same converged network port you selected in Step 6.
15.
Select 6: Add a Target.
16.
Complete the interactive list of settings as follows:
a.
IPv6 Target? [off]: Press the Enter key to accept the default.
b.
TGT_iSCSI_Name []: Type the IQN of the iSCSI target to connect to, and then press the Enter
key.
c.
TGT_Port [3260]: If the setting is something other than 3260, enter 3260, and then press the
Enter key.
d.
TGT_TargetIPAddress [0.0.0.0]: Type the IP address of the target, and then press the Enter
key.
17.
Select 12: Save Target/CHAP Changes on the options menu.
This completes the iSCSI initiator configuration for connecting to the iSCSI target.
Configuring an iSCSI Initiator in Windows
1.
Double-click the OCC CLI desktop icon or enter gaucli in the CMD window to access the QCC CLI.
2.
Select 2: Adapter Configuration on the QCC CLI Main Menu.