Deleting old wwns from the wwn list, Changing the name or host mode of a host group – HP StorageWorks XP Remote Web Console Software User Manual
Page 61
1.
Start LUN Manager and display the LUN Manager window (
Selecting Icon under Fibre Folder)” (page 13)
).
2.
In the tree, select and right-click a host bus adapter ( ).
A pop-up menu appears.
3.
Select Delete WWN from the pop-up menu.
A message appears, asking whether you want to delete the host bus adapter (WWN).
4.
Click the YES button to close the message.
5.
Click the Apply button in the LUN Manager window.
A message appears and asks if you want to apply the setting to the storage system.
6.
Click the OK button to close the message.
The settings are applied to the storage system.
Deleting Old WWNs from the WWN List
If you disconnect a host that has been connected via a cable to your storage system, the WWN
for the host will remain in the WWN list of the LUN Manager window. To delete the WWN from
the WWN list, take the following steps:
1.
Start LUN Manager and display the LUN Manager window (
Selecting Icon under Fibre Folder)” (page 13)
).
2.
In the WWN list, locate WWNs that are not registered in any host group. If the host group
column is blank, the WWN is not registered in any host group. Next, from these WWNs,
select the WWN that you want to delete, and then right-click the selection.
A pop-up menu appears.
3.
Select Erase WWN from the pop-up menu.
4.
Click the Apply button in the LUN Manager window.
A message appears and asks if you want to apply the setting to the storage system.
5.
Click the OK button to close the message.
The settings are applied to the storage system.
Changing the Name or Host Mode of a Host Group
Use LUN Manager to change the name or host mode of a host group. You cannot perform this
operation on host groups for initiator ports.
CAUTION:
Before you change the host mode of a host group, HP recommends that you first back
up the data on the port to which the host group belongs. The operation for setting the host mode
is not destructive, but data integrity cannot be guaranteed without a backup.
To change the name and/or the host mode of a host group:
1.
Start LUN Manager and display the LUN Manager window (
Selecting Icon under Fibre Folder)” (page 13)
).
2.
In the tree, select and right-click the host group.
3.
Select Change Host Group from the pop-up menu.
The Change Host group dialog box (
“Change Host Group Dialog Box” (page 62)
) appears.
Changing the Fibre Channel LU Path Settings
61