HP Designjet Z3200 PostScript Photo Printer series User Manual
Page 54
Alternatively, you can use the
Up
and
Down
keys to remove more or less of the paper (minimum 2
inches). Open the window to see where the cut will be made, indicated by a scissors label at the side
of the carriage. The window can remain open while you are moving the paper. When you have finished
moving the paper, close the window and press the
OK
key.
NOTE:
The printer may not cut the paper immediately, as the printheads are serviced after each print
and the paper cannot be cut until that process is complete.
When the paper has been cut, remove the cut piece from the output tray.
NOTE:
If strips or short prints are left in the output tray the printer could jam.
NOTE:
Photo and coated paper requires careful handling, see
The print is scuffed or scratched
44
Chapter 4 Paper handling
ENWW
P
ape
r ha
n
d
lin
g