HP PSC 1510xi All-in-One Printer - Manual (Page 20)

For best results, set the paper type and paper size before copying or printing. For
information on changing paper settings, see the onscreen
HP Image Zone Help .
Tip To help prevent rips, wrinkles, and curled or bent edges, store all paper
flat in a resealable bag. If the paper is not stored properly, extreme changes in
temperature and humidity might result in curled paper that does not work well
in the HP All-in-One.
To load 10 x 15 cm (4 x 6 inch) photo paper
1.
Remove all paper from the paper tray.
2. Insert the stack of photo paper into the far right side of the paper tray with the
short edge forward and the glossy side down. Slide the stack of photo paper
forward until it stops.
If the photo paper you are using has perforated tabs, load the photo paper so that
the tabs are closest to you.
3. Squeeze and hold the tab on the top of the paper-width guide, then slide the
paper-width guide inward against the stack of photo paper until it stops.
Do not overload the paper tray; make sure the stack of photo paper fits within the
paper tray and is no higher than the top of the paper-width guide.
Load postcards or Hagaki cards
You can load postcards or Hagaki cards into the paper tray of your HP All-in-One.
For the best results, set the paper type and size before printing or copying. For more
information, see the onscreen
HP Image Zone Help .
To load postcards or Hagaki cards
1.
Remove all paper from the paper tray.
2. Insert the stack of cards into the far right side of the paper tray with the short
edge forward and the print side down. Slide the stack of cards forward until it
stops.
3. Squeeze and hold the tab on the top of the paper-width guide, then slide the
paper-width guide inward against the stack of cards until it stops.
Do not overload the paper tray; make sure the stack of cards fits within the paper
tray and is no higher than the top of the paper-width guide.
User Guide 17
Load
originals
and
load
paper