HP PSC 1510xi All-in-One Printer User Manual
Page 64
6.
To reinstall the software, insert the HP All-in-One CD-ROM into your computer’s
CD-ROM drive, and follow the onscreen instructions and the instructions provided
in the Setup Guide that came with your HP All-in-One.
7.
After the software is installed, connect the HP All-in-One to your computer.
8.
Press the
On
button to turn the HP All-in-One on.
After connecting and turning on your HP All-in-One, you might have to wait
several minutes for all of the Plug and Play events to complete.
9.
Follow the onscreen instructions.
When the software installation is complete, the Status Monitor icon appears in the
Windows system tray.
To verify that the software is properly installed, double-click the
HP Director
(or
HP Solution Center
) icon on the desktop. If the
HP Director
(or
HP Solution
Center
) shows the essential icons (
Scan Picture
,
Scan Document
, and
HP Image
Zone
), the software has been properly installed.
To uninstall from a Windows computer, method 2
Note
Use this method if
Uninstall Software
is not available in the Windows
Start menu.
1.
On the Windows taskbar, click
Start
,
Settings
,
Control Panel
.
2.
Double-click
Add/Remove Programs
.
3.
Select
HP PSC & OfficeJet 4.5
, and then click
Change/Remove
.
Follow the onscreen instructions.
4.
Disconnect your HP All-in-One from your computer.
5.
Restart your computer.
Note
It is important that you disconnect your HP All-in-One before
restarting your computer. Do not connect the HP All-in-One to your
computer until after you have reinstalled the software.
6.
Launch setup.
7.
Follow the onscreen instructions and the instructions provided in the Setup Guide
that came with your HP All-in-One.
To uninstall from a Windows computer, method 3
Note
This is an alternate method if
Uninstall Software
is not available in the
Windows Start menu.
1.
Run the HP PSC 1500 All-in-One series software Setup program.
2.
Select
Uninstall
and follow the onscreen directions.
3.
Disconnect your HP All-in-One from your computer.
4.
Restart your computer.
Note
It is important that you disconnect your HP All-in-One before
restarting your computer. Do not connect the HP All-in-One to your
computer until after you have reinstalled the software.
5.
Run the HP PSC 1500 All-in-One series software Setup program again.
User Guide
61
Troubleshooting
information