HP Designjet 4000 Printer series - Manual (Page 13)

The front panel has the following components:
1.
The display area, where information, icons, and menus are displayed.
2. The Power key turns the printer on and off. If the printer is in sleep mode, this
key will wake it up.
3. The Power light is off when the printer is off; amber when the printer is in sleep
mode; green when the printer is on; green and flashing when the printer is in
transition between off and on.
4. The Form Feed and Cut key normally ejects the sheet (if a sheet is loaded) or
advances and cuts the roll (if a roll is loaded). However, if the printer is waiting for
more pages to be nested, this key cancels the waiting time and prints the
available pages immediately.
5. The Reset key restarts the printer (as if it were switched off and switched on
again). You will need an implement with a narrow tip to operate the Reset key.
6. The Cancel key cancels the current operation. It is often used to stop printing the
current print job.
7. The Status light is off when the printer is not ready to print: it may be off, or in
sleep mode. It is green when the printer is ready and idle; green and flashing
when the printer is busy; amber when a serious internal error has occurred;
amber and flashing when awaiting human attention.
8. The Up key moves to the previous item in a list, or increases a numerical value.
9. The Select key selects the item that is currently highlighted.
10. The Back key goes back to the previous menu. If you press it repeatedly, or hold
it down, you will soon return to the main menu.
11. The Down key moves to the next item in a list, or decreases a numerical value.
To highlight an item in the front panel, press the Up or Down key until the item is
highlighted.
To select an item in the front panel, first highlight it and then press the Select key.
11
Introduction