HP Jetdirect 70x home Print Server - Manual (Page 23)

18 Troubleshooting
HP JetDirect 70X Setup Wizard Problems
Condition Possible Cause/Solution
I put the setup CD in my
CD-ROM drive, but nothing
happens. • Try to manually run the setup CD. Click
Start. Click Run. Type in D:\setup.exe,
where D is the drive letter of your CD-ROM
drive. Click OK. The setup program should
run.
• If the setup CD doesn’t run, verify your CD-
ROM drive is working properly by trying to
run another CD.
• If another CD works, the HP JetDirect 70X
setup CD could be defective. Contact HP.
After I start the setup CD,
I’m getting a dialogue box,
saying that the system does
not have the appropriate
networking configuration. The setup CD could not find your home
phoneline network interface device. Verify that
the network is working, as described in the
documentation for your home phoneline
network interface device.
Then try to run the HP JetDirect 70X setup CD
again.
During setup, the computer
begins dialing up my
Internet Service Provider. Click Cancel when you see the “Dialing...”
dialogue box. The Setup Wizard will continue.
When I ran the setup CD, I
got the following error
message: “Hard Disk Full”. You will need to delete some files to create more
space on your hard disk.Then try to run the HP
JetDirect 70X setup CD again.
When I ran the setup CD, I
got the following error
message: “Insufficient
Memory”. Close any open programs. Then try to run the
HP JetDirect 70X setup CD again.