HP XP Continuous Access Software - Manual (Page 108)

The primary and secondary data volumes are not synchronized. Either of
the following:
– The operation for splitting the mirror is finished.
– The operation for deleting the mirror is in progress.
Stop
an XP Continuous Access Journal pair for delta resync operation is created.
Hold
An error occurred with the XP Continuous Access Journal pair for the delta
resync operation.
Hold (Failure)
No data volumes are registered in this journal group. Blank
◦ Mirror ID: Mirror ID. This column is blank if the journal group's attribute is neither Master
nor Restore.
◦ S/N: Remote array's serial number. This column is blank if the journal group's attribute
is neither Master nor Restore.
◦ Pair JNLG: Number of a journal group in the remote array. This column is blank if the
journal group's attribute is neither Master nor Restore.
◦ Controller ID: Remote array's controller ID (that is, array family ID). This column is blank
if the journal group's attribute is neither Master nor Restore.
NOTE: The controller ID for an XP12000/XP10000 is 4.
◦ Path Gr. ID: Path group IDs, which are used to identify path groups (that is, groups of
logical paths). Up to eight logical paths can be registered in one path group. This column
is blank if the journal group's attribute is neither Master nor Restore.
◦ CLPR: Displays the CLPR number for the journal group. If more than one JNL volume is
registered in JNL group, the CLPR number of the first registered JNL volume is displayed.
The first registered JNL volume is displayed at the top of JNL volume list in JNL Group
Detail panel.
◦ CTG: Number of a consistency group to which the mirror belongs. This column is blank
if the journal group does not have any volume pair.
•
Preset: Detailed information about operations that will occur when you click Apply.
List: Displays changes made in the pane. When you change settings in the pane, changes
appear in the Preset list before the changes are applied to the arrays. If you are sure that
information in the Preset list is correct, click Apply to apply the settings. ◦
NOTE: When the Preset list displays changes that have been made, you can only
perform the same type of operation that you have been doing, and cannot perform most
other operations. You can only view detailed information about journal groups even when
the Preset list displays changes. For example, if you are trying to delete journal groups
and the Preset list displays the journal groups you want to delete, you cannot perform
other operations, such as splitting or restoring mirrors.
◦ Operation: Operation that will occur when you click Apply.
Edit JNL Volumes: Register or delete journal volumes –
– Change JNL Option: Change journal group options
– Delete JNL Groups: Delete journal group
– Pairsplit -r: Split a mirror
– Pairresync: Restore a mirror
108 Using journal groups