HP XP Continuous Access Software - Manual (Page 98)

4. In the Switch Display box, select DKC.
5. Do one of the following:
•
In the tree, select a remote array.
•
In the list, right-click a remote array, and select Edit Path(s). The list displays information
about logical paths.
6. Right-click the list, and select Add Path. The Add Path pane appears.
7. Use the Add Path pane to configure up to eight new logical paths.
8. Click Set to close the Add Path pane.
9. In the Preset list, check the settings you made.
•
To modify a setting, right-click the setting from the Preset list, and select Modify. A pane
appears where you can modify the setting.
•
To cancel a setting, right-click the setting in the Preset list, and select Cancel.
10. Click Apply to apply the settings.
NOTE: If an error occurs, the right-most column of the Preset list displays the error code. To
view detailed information about the error, right-click the error code, and select Error Detail.
An error message appears providing detailed information about the error.
Figure 45 Add Path pane
•
Port: Select an initiator port on the local array.
NOTE: When specifying a port, use the keyboard to enter the port number. When entering
the port number, you can abbreviate the port number to two characters. For example, you
can enter 1A instead of CL1-A. You can use uppercase and lowercase letters.
•
Pair-Port: Select an RCU target port on the remote array.
98 Configuring arrays and logical paths