HP XP Continuous Access Software - Manual (Page 182)

Table 51 Example of XP RAID Manager configuration definition file at secondary site (instance 17)
HORCM_MON
#ip_address service poll(10ms) timeout(10ms)
123.456.80.51 20332 1000 3000
HORCM_CMD
#dev_name dev_name dev_name
#UnitID 0 (Serial# 62490)
/dev/sdf
HORCM_DEV
#dev_group dev_name port# TargetID LU# MU#
# /dev/sdt SER = 62486 LDEV = 10 [ FIBRE FCTBL = 3 ]
VG_TC VG_032 CL1-A-1 0 10
# /dev/sdu SER = 62486 LDEV = 64 [ FIBRE FCTBL = 3 ]
VG_TC VG_033 CL1-A-1 0 11
# /dev/sdv SER = 62486 LDEV = 12 [ FIBRE FCTBL = 3 ]
VG_TC VG_034 CL1-A-1 0 12
# /dev/sdw SER = 62486 LDEV = 66 [ FIBRE FCTBL = 3 ]
VG_TC VG_035 CL1-A-1 0 13
# /dev/sdan SER = 62486 LDEV = 30 [ FIBRE FCTBL = 3 ]
VG_SI VG_014 CL1-A-1 0 30
# /dev/sdao SER = 62486 LDEV = 84 [ FIBRE FCTBL = 3 ]
VG_SI VG_015 CL1-A-1 0 31
# /dev/sdap SER = 62486 LDEV = 41 [ FIBRE FCTBL = 3 ]
VG_SI VG_016 CL1-A-1 0 32
# /dev/sdaq SER = 62486 LDEV = 86 [ FIBRE FCTBL = 3 ]
VG_SI VG_017 CL1-A-1 0 33
HORCM_INST
#dev_group ip_address service
VG_TC 123.456.78.51 20331
VG_TC 123.456.78.115 20331
VG_SI 123.456.80.51 20331
VG_SI 123.456.80.115 20331
Setting the XP RAID Manager user environmental variable
In the following procedure, the environment variables HORCMINST and HORCC_MRCF are corrected
corresponding to a system configuration. This setup is performed on the four nodes (CL1 and CL2
of the cluster to which the XP Continuous Access Journal P-VOL is connected, and CL1 and CL2 of
the cluster in which the S-VOL is used).
1. At both sites, set up the environment variable of the XP RAID Manager instance:
sudo horc_setenv HORCMINST 16 (for instance number 16)
sudo horc_setenv HORCMINST 17 (for instance number 17)
2. At both sites, set up the HOMRCF command environment variable of the XP RAID Manager as
XP Continuous Access Journal:
sudo horc_unsetenv HORCC_MRCF
182 XP Continuous Access Journal operations with NAS Blade