HP ProLiant BL460c Gen8 Server Blade - Manual (Page 13)

Operations 13
Remove the access panel
To remove the component:
1. Power down the server blade (on page 11 ).
2. Remove the server blade (on page 12 ).
3. Press the access panel release button.
4. Slide the access panel towards the rear of the server blade, and then lift to remove the panel.
Install the access panel
1. Place the access panel on top of the server blade.
2. Slide the access panel forward until it clicks into place.
Remove the front panel/hard drive cage assembly
1. Power down the server blade (on page 11 ).
2. Remove the server blade (on page 12 ).
3. Remove the access panel (on page 13 ).
CAUTION: Always remove the SAS controller before removing the front panel/drive cage
assembly.
4. Extend the serial label pull tab from the front of the server blade.
5. Remove the two T-15 screws from the front panel/drive cage assembly.
6. Remove the front panel/drive cage assembly.
Remove the DIMM baffle
1. Power down the server blade (on page 11 ).