HP ProLiant BL460c Gen8 Server Blade - Manual (Page 34)

Hardware options installation 34
7. Install the DIMM.
8. Install all DIMM baffles.
9. Install the access panel (on page 13 ).
To configure the memory mode, use RBSU (" HP ROM-Based Setup Utility " on page 51 ).
Mezzanine card option
Optional mezzanine cards are classified as Type A mezzanine cards and Type B mezzanine cards. The type
of the mezzanine card determines where it can be installed in the server blade.
• Install Type A mezzanine cards on Mezzanine 1 connector or Mezzanine 2 connector.
• Install Type B mezzanine cards on Mezzanine 2 connector.
Optional mezzanine cards enable network connectivity or provide Fibre Channel support. For mezzanine
card locations, see the system board components (on page 8 ).
When installing a mezzanine option on mezzanine connector 2, processor 2 must be installed.
For mezzanine card mapping, see the HP ProLiant BL460c Gen8 Server Blade Installation Instructions or see
"Interconnect bay numbering and device mapping (on page
18 )."
To install the component:
1. Power down the server blade (on page 11 ).
2. Remove the server blade (on page 12 ).
3. Remove the access panel (on page 13 ).