HP NetRAID 1 Controller - Manual (Page 73)

69
CAUTION Do not place the HP NetRAID battery backup module or the HP NetRAID
adapter card on a conductive surface while the battery is being attached.
Connecting Battery Packs
The HP NetRAID battery backup module usually is shipped with an onboard four-cell Nickel-Metal
Hydride battery pack already installed. If this is the case, you must only insert the battery connector
into J2, as shown in the following figure. The battery cable connector is keyed to make sure that the
proper connection is made, as demonstrated in the following figure.
Attaching the Battery Pack Connector to J2