HP Scitex FB950 Printer series - Manual (Page 33)

17. Tape the end of the media to printer side of takeup roller, starting in the middle and working out to
both ends.
Be sure to maintain even tension across the width of the media.
18. Release the dancer bar locking lever.
19. Press the Proceed ( ►) key.
20. Enter the media length or press the Esc key for an undefined length.
The printer measures the media width.
21. On the Front Page screen, press the Proceed ( ►) key.
The Front Page screen appears on the control panel.
22. Press the Go Online key.
The printer is now ready to receive a print job from the RIP.
Restore loaded state
1. As prompted by the control panel, remove the foam press roller, then press the Proceed ( ►) key.
2. Press the upper (forward) Advance Media key to advance the media to the takeup spool and/or
past any printed area of the media.
3. On the control panel, press the Turn Off Fans key.
4. Hold the upper (forward) Advance Media key down for about five seconds.
5. On the control panel, press the Turn On Fans key.
6. Press the Proceed ( ►) key.
7. Check for wrinkles in the media across the full length and width of the belt.
If you see any wrinkles, turn off the fans and smooth them out with your hand. Repeat steps 3
through 7 until no wrinkles are visible.
8. Place the foam press roller (3) into operating position.
9. If you are not using the takeup system, or if the media is already loaded in the takeup, go to step
15.
10. Align the cardboard takeup core to the media and tighten the collets to lock the core in place.
11. Lift the first dancer bar (6) (with the gears), and lock in the upper position.
12. Pull the media under the first dancer bar, over second dancer bar (7), and down to the printer side
of takeup roller (8).
Looking down the length of the takeup roller from the user end, the roller rotates clockwise. Ensure
that the media is wrapped as shown in
Figure 2-1 Roll-fed media path on page 25 .
13. Tape the end of the media to printer side of takeup roller, starting in the middle and working out to
both ends.
Be sure to maintain even tension across the width of the media.
ENWW Load and print on roll-fed media 27