HP Scitex FB950 Printer series - Manual (Page 54)

●
Carriage Motion
●
Calibration
●
Verify H2H Y Alignment — verifies whether the print heads are aligned with each other (in the
horizontal or Y-axis dimension) in-line or staggered, by printing a test pattern. If the lines print on
top of each other, the heads are in-line; if they print interleaved with each other, the heads are
staggered. The current Y alignment is shown in the About screen (to access it, press the printer
name in the top center of the Front Page screen).
●
Vacuum Pressure
●
Open Loop Actuator Test
●
Warnings and Actions List — table of all actions and warnings with cause and recovery
●
Error History — displays a list of errors that have occurred since the printer was last powered up.
●
Log Error History — writes a file containing all of the errors that have occurred on the printer since
the printer was put into service, for troubleshooting by technical support personnel. The file is saved
on the computer running the HP RIP Software at:
C:\PROGRAM FILES\HP-RIPSW\LOGS\C3.TXT
● Log System Info — general system events, including head motion failures and printhead purges,
are now saved to a log file for troubleshooting by technical support personnel. The file is saved on
the computer running the HP RIP Software at:
C:\PROGRAM FILES\HP-RIPSW\LOGS\C3.TXT
Alternatively, the log can be printed (Service Printer > Print Info Pages) and mailed or faxed.
Warnings & Actions
When in Expert mode, any current Warning, Change, and Action messages can be displayed by
selecting Warnings & Actions from the menu. When in Novice mode, press the ATTN icon on the Front
Page screen to view these messages.
Service Printer
These functions are primarily for factory, service, and technical support use.
●
Set Head Vacuum — enables you to reset the printhead vacuum level. Not recommended without
guidance from HP technical support.
Print Menus
This option prints all of the menu options in a hierarchical tree format for reference.
48 Chapter 3 Control panel ENWW