Displaying factory default mac and wwn addresses, Deleting wwn exclusion ranges – HP Virtual Connect Enterprise Manager Software User Manual
Page 115
For more information, go to:
select the Product
Documentation Quick Link, then look in the White Papers section for the HP Matrix Operating
Environment Federated CMS Overview White Paper.
Displaying factory default MAC and WWN addresses
NOTE:
There is not any label or attribute indicating the MAC/WWN displayed is a factory
default or not, it is up to you to identify that.
For VC firmware 3.70 and later, you can view factory default MAC and WWN addresses for:
•
The server profile edit page for assigned server profiles
•
The server profile edit page for unassigned server profiles
•
Each server profile edit page with Advanced Settings
•
Imported server profiles from VCM with mixed connections (user-defined and factory default).
•
The Server Profile Information details link
shows the Server Profile Information details link
Figure 51 Server Profile Information details
NOTE:
Factory default address information is only available for mapped connections.
Connections which are unmapped will continue to display as Factory-Default.
Deleting WWN exclusion ranges
1.
From the VCEM home page, under the Administration heading, click the World Wide Names
hyperlink.
2.
From the Select ranges to configure list, select WWN.
3.
Select a WWN address range. The exclusion range must be contained within the address
range to which the exclusion range belongs.
IMPORTANT:
After upgrading to VCEM 1.4x or later, HP recommends that you delete any
exclusion ranges for HP predefined MAC and WWN addresses.
Deleting WWN exclusion ranges
115