HP XP Racks User Manual
Page 86
Description
Error code
(SSB2)
The P-VOL is in the process of drive copy for failure assistance.
C316
The P-VOL is in the process of drive copy for an SVP request.
C317
The P-VOL is terminating the copy task.
C318
The P-VOL is in the process of collection copy.
C319
The P-VOL is in the process of collection access.
C31A
The P-VOL is blocked.
C31B
The P-VOL is blocked and impossible to access.
C31C
The P-VOL is being formatted.
C31D
The P-VOL is read only.
C31E
The number of remote paths is 0 (not specified).
C320
The number of remote paths is smaller than the minimum required.
C321
The DKC type of the primary system does not support Cnt Ac-S.
C322
The secondary system's sequence number, SSID, or CU are invalid.
C324
The pair cannot be created because the P-VOL is not available for remote copy.
C327
The track formats of the P-VOL and the S-VOL do not match.
C328
The S-VOL is protected by the Data Retention.
C32A
The P-VOL is protected by the Data Retention.
C32B
The S-VOL is protected by the Data Retention.
C32C
The S-VOL is protected by the Data Retention.
C32D
A request for a Paircreate operation was rejected because the specified secondary system is an unsupported
product.
C32E
The number of P-VOL cylinders is not the same or smaller than the number of S-VOL cylinders.)
C32F
The pair cannot be created or resynchronized because P-VOL and S-VOL capacities are not the same, or
because the S-VOL is in a LUSE configuration.
C330
S-VOL cache is unavailable.
C332
S-VOL DFW is disabled.
C333
The S-VOL is the Cnt Ac-S P-VOL.
C335
The S-VOL includes PIN data.
C336
The S-VOL is in reserve status.
C337
Copy pair cannot be created because of the either of the following reasons.
C338
•
The S-VOL is in the intervention-required condition, protected, or unusable status.
•
The S-VOL is the S-VOL or Reserved volume of Business Copy, Reserved volume of Auto LUN, or the
volume of Cnt Ac-J pair.
The S-VOL is not available.
C339
A request for a Paircreate operation was rejected because the secondary system is a not supported by Cnt
Ac-S.
C33A
The corresponding volume cannot be specified as an S-VOL because the volume is used as another pair's
S-VOL.
C33B
86
Troubleshooting