HP XP Racks - Manual (Page 87)

Description Error code
(SSB2)
A request for a Paircreate operation was rejected because the specified S-VOL was not mounted. C33C
The pair cannot be created because the S-VOL is not implemented or is blocked (DEV NOT READY status). C33E
The corresponding volume cannot be specified as an S-VOL because the volume is already specified as a
Cnt Ac-S pair volume. C33F
The P-VOL is not accessible. C35C
There are fewer paths than the required minimum following a path failure or because an invalid path was
specified. C370
The process that is performed after the copying process of Auto LUN in the S-VOL is in progress. Retry the
operation several minutes later. C371
The process that is performed after the copying process of Auto LUN in the P-VOL is in progress. Retry the
operation several minutes later. C372
A request for a Paircreate operation was rejected because the specified S-VOL is a Business Copy Reserved
volume. C373
A request for a Paircreate operation was rejected because the specified P-VOL is a Business Copy Reserved
volume. C374
There are fewer paths than the required minimum following a path failure or because an invalid path was
specified. C379
An internal error occurred. C37A
The S-VOL is not available. C37B
The S-VOL cache is unavailable. C37E
The S-VOL DFW is disabled. C37F
The primary system cache is in transition to blockage on one side. C380
The primary system cache is in the process of being restored. C381
The primary system cache is either in transition to blockage on one side or in the process of being restored
on one side. C382
The pair cannot be created because the emulation type is not available for the specified volume. C388
The secondary system is already used by Cnt Ac-S. C38B
The S-VOL is not available. C38D
The S-VOL is not supported by Cnt Ac-S. C38E
The S-VOL status is not PSUS or PSUE. C390
The S-VOL cannot be copied to because it is in the wrong pair status. C391
The volume cannot be used as an S-VOL because it is in reserve status, is already being used by Cnt Ac-S,
or is being used by Cnt Ac-J. C392
The S-VOL includes PIN data. C393
The S-VOL cannot be used due to LDEV blockage, collection access, or other reasons. C395
The pair cannot be created because the emulation type is not available for the specified volume. C398
An internal error occurred. C39B
The pair cannot be created because the capacity of the P-VOL exceeded the maximum volume capacity
allowed to create a Cnt Ac-S pair. C39E
The pair cannot be created because the capacity of the S-VOL exceeded the maximum volume capacity
allowed to create a Cnt Ac-S pair. C39F
Troubleshooting using RAID Manager 87