Removing the usb interface cable, Assembling the stand, Removing the usb interface cable –2 – HP Point of Sale rp5000 User Manual
Page 12: Assembling the stand –2
3–2
www.hp.com
User Guide
Setting Up the Scanner
2. Gently tug the cable to ensure the connector is properly
secured.
3. Connect the other end of the interface cable into a USB port
on the POS computer.
Removing the USB Interface Cable
1. Unplug the installed cable’s modular connector by depressing
the connector clip with the tip of a screwdriver.
2. Carefully slide out the cable.
Assembling the Stand
The stand allows hands-free scanning when attached to the
scanner.
1. Unscrew the wingnut from the bottom of the neckpiece
scanner cup.
2. Fit the bottom of the neck piece 1 into the opening on the top
of the stand base 2.
3. Tighten the wingnut 3 underneath the base to secure the cup
and neck piece to the base.
✎
Before tightening the wingnut under the base, ensure that the flat
areas on the flexible neck fit securely in the grooves in the base.