Errors while scanning, User preferences default parameters – HP Point of Sale rp5000 User Manual
Page 46
5–2
www.hp.com
User Guide
Programming User Preferences
or setting Data Transmission Formats, require that you scan
several bar codes. Refer to “Laser On Time” in this chapter and
“Scan Data Transmission Format” in the Programming Reference
Guide on the software and documentation CD for descriptions of
this procedure.
Errors While Scanning
Unless otherwise specified, if you make an error during a
scanning sequence, just re-scan the correct parameter.
User Preferences Default Parameters
The following table lists the defaults for user preferences
parameters. If you want to change any option, scan the
appropriate bar code(s) provided in the “User Preferences”
section of this chapter.
User Preferences Default
Parameter
Default
Set Default Parameter
All Defaults
Beeper Tone
Medium
Beeper Volume
High
Power Mode
Continuous On
Laser On Time
3.0 Sec.
Beep After Good Decode
Enable