ABL electronic Scamax 5000 - Manual (Page 26)

DpuScan
Scamax 2600 / 5000 Scanner Options
Page Counter A will always be incremented by 1. Only if Counter A
was reset as the result of an event (Patchcode found, for example)
will the counter be incremented for the next image by a user-defined
value. Afterwards, the counter will be incremented by 1 again.
Reset Value (reset the
counter to a certain
value) As a result of an event, the corresponding counter will be reset to the
entered value. For example, the page counter can be reset to 0 when a
new chapter begins. The reset value must be in a valid range, and it must
be within the defined field width, as seen in the notes above.
Trigger Value (to cause
an event) This defines which count causes an event. For example, the scan job can
be stopped after 200 pages.
The trigger value must also be in the valid range, as seen in the preceding
notes.
Page 26 of 42