ABL electronic Scamax 5000 - Manual (Page 25)

Scanner Options Scamax 2600 / 5000
DpuScan
5.3.2 How to Set and to Trigger Counters
Illustration 8 – Counter Modes
Field Width This define how many digits the counter should have. If it is set to, for
example, 3 digits, the counter will count from 0 to 999. After that it resets
to 0 again.
Be aware that the reset and trigger value must be "in range”. In this
example, use a value before counter 1000, because 1000 will never
be reached.
We recommend the use of higher numbered digits for a lower level, and a
lower number of digits for a higher level. For example, if there are many
pages in just a few chapters, 6 digits should be chosen for the Page
Counter, and 2 digits for the Chapter Counter.
If a counter – including the automatic Page Counter A - has a field
width of zero, this counter will not be incremented and interpreted.
The Sequential ID will be incremented always as expected.
Increment Value (by a
certain value) As a reaction to an event, the corresponding counter will be incremented
by the entered value. For example, the chapter counter can be
incremented while the page counter is at reset value.
Page 25 of 42